<<Back
|
 Cloridox-GMP
The
Cloridox-GMP Sterilization System is portable in design and is
comprised of a gas generation section and a sensing/electronic
section. These are used in conjunction with an operator
control and monitoring system. The PLC system controls and monitors
pressures, temperatures, relative humidity, and chlorine dioxide
gas concentration during the operating cycle. A sophisticated
operator interface system allows for easy cycle development and
cycle selection. A documented run record is produced which includes
all of the critical process parameters. An optional steam inject
module delivers steam to raise relative humidit to within a specified
range.
|
Dimensions
•Dimensions:
43" Wide x 62" High x 28" Deep
•Weight:
600 lbs.
Utility
Requirements
Utility
Requirements at Point-of-Use
•100
- 240 VAC, 5 amp, single phase
•20
psi steam (for optional Steam Injector)
•15
cfm, negative pressure exhaust
Utility
Requirements at Consummable Changeout Station
•60-100
psi, 25 cfm, clean, dry compressed air
•15
cfm, negative pressure exhaust
•100
- 240 VAC, 5 amp, single phase |
|
Cloridox-B
The
non-GMP version of the Cloridox-GMP is available as a low cost
CD generation system for applications that don't require full
GMP systems. It is especially suited for room decontamination.
Dimensions
•Dimensions:
43" Wide x 62" High x 28" Deep
•Weight:
600 lbs.
Utility
Requirements
Utility
Requirements at Point-of-Use
•100
- 240 VAC, 5 amp, single phase
•20
psi steam (for optional Steam Injector)
•15
cfm, negative pressure exhaust
Utility
Requirements at Consummable Changeout Station
•60-100
psi, 25 cfm, clean, dry compressed air
•15
cfm, negative pressure exhaust
•100
- 240 VAC, 5 amp, single phase |
|
Cloridox-DS
 The
Cloridox-DS Sterilization System can completely control a cycle
for a wide range of research and production applications within
a given chamber. The typical chlorine dioxide gas generating
system consists of the following modules:
• A
Gas Generator Module that produces the gaseous sterilizing agent,
fully controls the sterilization process, and provides a 8"
x 11.5" run record
• Dedicated
to each chamber are the following:
•A
Gas Inject Module for the delivery of gas into the chamber
•A
Sensor Module for monitoring process parameters
|
|
Dimensions
•Dimensions:
70" Wide x 70" High x 22" Deep
•Weight:
1250 lbs.
Utility
Requirements
•80-100
psi, 25 cfm, clean, dry compressed air
•15
cfm, negative pressure exhaust
•Power
requirements configurable for the following voltages:
•100
+/- 10%VAC, 15 amp, single phase
•120
+/- 10%VAC, 15 amp, single phase
•220
+/- 10%VAC, 10 amp, single phase
•230
+/- 10%VAC, 10 amp, single phase
•240
+/- 10%VAC, 10 amp, single phase
•20
psi steam (for optional Steam Injector)
Available
Options
•Fixed
Length Steam Inject Module - #1003
•Adjustable
Length Steam Inject Module - #1005
•Vacuum
Sensor Module - #1006
•Photometer
Calibration Filter Set - #1007 |
|
